It is really different to utilize a stand-up forklift compared to a sit-down unit. The way you move and lift cargo along with your movements are completely different. If you do not have proper training for operating a stand-up unit, you could probably cause harm to yourself or to co-workers. When operating a stand-up unit, you should follow the proper safety regulations. There are several basic operating standards that must be met when using a stand-up model.
When beginning, stand up on the forklift so as to get a feel for the controls and the steering knob. The steering is handled utilizing the knob steering plate rather than a steering wheel. Remember that this particular knob moves really fast, therefore, you should be accustomed to moving it gently so as to be sure not to over steer. The horn is located on the control handle, as is the control for backwards, forwards and the movement of the forks. The floor pedal allows the machinery to move.
If you are ready to start, turn the key to start the equipment. Be sure that your forks are not extended. When you are moving around the floor, the forks should be pointed a little upwards. Do not drive with extended forks. If you are traveling forwards, move the control handle forward and step on the pedal in order to make the lift move forward. If you are backing up, be sure to beep your horn so as to alert those around you. Look behind you prior to stepping on the pedal in order to make sure the path is clear and safe. After that, pull the control handle towards you while stepping on the pedal. Stay focused and alert and make sure that you are always operating in a safe manner.
When approaching a corner with the lift truck, turn the steering knob in the direction you are heading. Make sure to keep your foot on the accelerator and keep your hands on the control handle. When turning right, the steering knob will move in a clockwise direction while moving forward. If you are turning left, your steering knob would go in a counter-clockwise direction.
The stand-up units take some getting used to, specially if you have only used sit down models. If you take some time to know the machinery and with some training, you could efficiently and quickly handle loads in little time.